1. Power On/Off:

When switch upside, the device powers on, the green light flashes once, and a “power on” voice prompt is heard,

 then comes “ pairing” prompt when in first time power on the device. Future shall long push “+” volume button 6 seconds to activate bluetooth pairing mode.

When the switch is turned off, the device powers off immediately without a voice prompt.

 2. Pairing via Bluetooth:

First, be sure your smart phone bluetooth is on, and power on the hearing device; the device enters Bluetooth pairing mode 

(if need to connect with another bluetooth device, please long push “+” 6 seconds to activate pairing mode). The light will alternate between green and blue;

Click: Realink iEarton Abox name in your smart phone bluetooth list, there will be “connected” beep. Once pairing is complete,

 the hearing aids will automatically reconnect to your phone the next time they are turned on.

3. Volume Adjustment:

The hearing aids have five volume levels. Briefly press the “+” volume button to increase the volume;

briefly press the “–” volume button to decrease the volume;

Each short press of a volume button adjusts the volume by one level and is accompanied by a single “beep.”

When the volume reaches the maximum or minimum level, two “beeps” will sound.

4. Charging the Hearing Aids:

a. Turn off the hearing aids before charging.

The red light will be on while charging and will

turn off when fully charged.

b. It takes about three hours to fully charge the

hearing aids.